Template Validation Status Code

Overview

Status codes are received after executing Vitrage template validation. The code describes the Vitrage template status: if the template is correct, the status code is 0. Otherwise the code describes the error in the template itself.

Description

The following describes all the possible status code and their messages:

code	message	Test Type
0	Template validation is OK	content and syntax
1	template_id field contains incorrect string value	content
2	Duplicate template_id definition	content
3	template_id does not appear in the definition block	content
4	Syntax error: [error message]	syntax
20	definitions section must contain entities field	syntax
21	definitions section is a mandatory section	syntax
41	Entity definition must contain template_id field	syntax
42	Entity definition must contain category field	syntax
43	At least one entity must be defined	syntax
45	Invalid entity category. Category must be from types: [entities_categories]	syntax
46	Entity field is required	syntax
60	metadata section must contain id field	syntax
62	metadata is a mandatory section	syntax
80	scenarios is a mandatory section	syntax
81	At least one scenario must be defined	syntax
82	scenario field is required	syntax
83	Entity definition must contain condition field	syntax
84	Entity definition must contain actions field	syntax
85	Failed to convert condition	content
100	Invalid relation type. Relation type must be from types: [relation_types]	syntax
101	Relationship field is required	syntax
102	Relationship definition must contain source field	syntax
103	Relationship definition must contain target field	syntax
104	Relationship definition must contain template_id field	syntax

104 | Relationship definition must contain template_id field | syntax |

[action_types] | |

121	At least one action must be defined	syntax
122	Action field is required	syntax
123	Relationship definition must contain action_type field	syntax
124	Relationship definition must contain action_target field	syntax
125	raise_alarm action must contain alarm_name field in properties block	content
126	raise_alarm action must contain severity field in properties block	content
127	raise_alarm action must contain target field in target_action block	content
128	set_state action must contain state field in properties block	content
129	set_state action must contain target field in target_action block	content
130	add_causal_relationship action must contain target and source field in target_action block	content
131	mark_down action must contain target field in target_action block.	content
132	add_causal_relationship action requires action_target to be ALARM	content